User Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installing and removing drives
36
A26361-K516-Z100-3-7619
Removing an accessible drive
Open the system unit (see "Opening the system unit").
2
1
3
Pull the data and the power supply connectors from the desired drive (1).
Remove the screws (2) and take the drive out of the system unit (3).
A
B
Insert the shielding plate (B) on the right-
hand side on the installation bay and press
it in.
Press the plastic drive cover (A) into the
front panel until it snaps in place.
Close the system unit (see "Assembling
the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.