User Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Installing and removing drives System expansions
A26361-K516-Z100-3-7619
35
Take the new drive out of its packaging.
Make the required settings on the drive (if necessary, on installed drives as well).
3
1
2
Slide the drive into the system unit (1).
Plug the connectors of the data cable and the power supply cable into the drive (2).
Fasten the drive with the screws (3).
Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.