Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Installation opening for 2nd serial port
42
A26361-K516-Z100-1-7619
Installing the hard disk carrier
2
1
²
Lift the chipcard reader into the system unit (1).
²
Push the chipcard reader into the carrier until it clicks into position (2).
i
With the chipcard reader connected, no devices may be connected to serial port 2.
Installation opening for 2
nd
serial port
An installation opening for the 2
nd
serial port is provided on the back of the casing. As a result, this
means no board slot is occupied.
²
Insert a screwdriver into the opening and break out the pre-stamped installation opening by
moving back and forth.