Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Installing and removing drives System expansions
A26361-K516-Z100-1-7619
37
Changing the floppy disk drive
²
Open the system unit (see "Opening the system unit").
2
3
1
²
Pull the data and the power supply connectors from the floppy disk drive (1).
²
Remove the screw (2).
²
Take the drive out of the system unit (3).
²
Take the new floppy disk drive out of its packaging.
3
1
2
²
Slide the drive into the system unit (1).
²
Plug the data and the power supply connectors into the floppy disk drive (2).
²
Fasten the drive with the screw (3).
²
Close the system unit (see "Assembling the system unit").
i
If necessary, you must adapt the entry for the drive in the Setup menu.