Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
System expansions Opening the system unit
30
A26361-K516-Z100-1-7619
Opening the system unit
²
Switch the PC off.
!
Please take note of the safety information in the chapter "Important notes".
Pull the power plug out of the power outlet!
²
If any cables attached to the system unit are obstructing you, pull out the connectors on the
system unit.
²
Place the system unit in a convenient working position.
1
3
4
2
a
²
Unlock the system unit (1).
²
Unlock the left-hand side cover with the locking slide at the rear of the casing by sliding it
upwards (2).
²
Push the side cover in the direction of the arrow (3) until the distance (a) is
approximately 10 mm.
²
Pull the side cover out of the casing (4).