Operating Manual
Table Of Contents
- Title
- Contents
- Introduction
- Important notes
- Preparation for use and operation
- Unpacking and checking the delivery
- Preparing the PC for use
- Setting up the PC
- Connecting devices
- Connecting the PC to the line voltage
- Unlocking/locking the system unit
- Switching the PC on and off
- Indicators on the system unit
- Keyboard
- Working with floppy disks
- Settings in BIOS Setup
- Property and data protection
- Troubleshooting and tips
- System expansions
- Technical data
- Index
Connecting devices Preparation for use and operation
A26361-K516-Z100-1-7619
13
Connecting the monitor to the line voltage
²
Prepare the monitor as described in the Operating Manual for the monitor.
²
Plug the data cable of the monitor into the monitor port of the system unit.
2
1
²
Depending on the connector, plug the monitor power cable into either the system unit (1) or the
grounded power outlet (2).
!
You may only plug the monitor power cable into the monitor connector if the rated current
of the monitor is less than 1.5 A (230 V) or 3 A (115 V). The rated current for the monitor
is also given on the monitor itself and in the Operating Manual for the monitor.