User Manual
Table Of Contents
- PalmSecure ID Match
- Important notes
- Ports and control elements
- Initial startup
- Using the palm scanner
- Restore factory default settings
- Using the SmartCard reader
- Using the magnetic card reader (optional)
- Using the Security Lock
- Technical data
Initial startup
Switching the device off
i
Depending on the operating system or application software, you can shut down the system
by command.
You will find information about this in the documentation for the operating system or the
application software.
If you shut down the device by pressing the On/Off switch for 4 seconds, this may lead to
loss of data.
1
► If the operating system does not automatically switch the device into power-saving mode or
switch it off, press the ON/OFF switch (1) on the bottom of the device for at least 4 seconds.
The device is switched off.
i
The ON/OFF switch does not disconnect the device from the mains voltage. To completely
disconnect from the mains voltage, you must remove the mains supply plug from the
mains supply socket.
21