User's Manual

Product information July, 2000

AS x88/TM: Linking PROFIBUS-PA

The contents of the file

PA_TREIB.INI

must be entered before line "EATASK.386" in the

file STARTER.INI, contained on the memory card. The modified file STARTER.INI must

then be copied to the memory card again.

For using the PROFIBUS-PA connection, two modules of the AS x88/TM system software

M02.00 have to be changed. For that copy the three files from the directory A:\M02_00.01

on your PC and transfer these files on the memory card too:

<ESC>COPY_TM EATASK.386

<ESC>COPY_TM FUNC.EXE

<ESC>COPY_TM VERSION1.TXT

Attention: The prelimiary version M02.00.01 must be installed only, if the issue of the

AS x88/TM system software existing on the memory card is

≤

M02.00/

M01.06! Up from version M02.01/M01.07 the files from A:\M02_00.01 must

not

be installed!

After successful transfer, exit the ASBEDIEN (with Alt-X). Then, please perform the

following action:

•

reBOOT the AS x88/TM (reset or OFF/ON).

Caution: The data transfer is successful only if the command COPY_TM terminates

without error message and manual intervention (e.g. cancellation with ESC).

In the case of an error, the copy procedure must be repeated.

If problems occur during data transfer (frequent disconnection), we

recommend to follow the procedure described for the AS software in the

product information.