Rugged Case - Chalice .fm Page 1 Monday, March 19, 2007 10:09 AM Fujitsu Computer Systems Corporation Rugged Tablet Case User’s Guide I N S T R U C T I O N S These instructions provide details on using the rugged tablet case with your Fujitsu LifeBook notebook when it is in tablet mode. The case provides added protection when transporting, using, or storing the notebook. We recommend that you read these instructions prior to using the case with your computer.
Rugged Case - Chalice .fm Page 2 Monday, March 19, 2007 10:09 AM D-rings (2 places} Pen Holder* Built-in microphone access Fingerprint sensor access Port/slot access Application button access System status/ power/suspend/ resume button access Figure 1. Rugged tablet case - Front The pen which came with the system is too small to fit snugly in the pen slot, so a full-size pen is included with the case. The pen holder on the top front of the case should be used to store the pen.
Rugged Case - Chalice .fm Page 3 Monday, March 19, 2007 10:09 AM Case handle PC Card access Hand strap slots Figure 2. Rugged tablet case - back Installing the hand strap The hand strap is designed to let you hold your system securely when it is installed in the case. Use of the hand strap is highly recommended. The hand strap consists of two parts, each of which has a Velcro strip on one end and a retaining bar at the other.
Rugged Case - Chalice .fm Page 4 Monday, March 19, 2007 10:09 AM 2. Insert the shorter of the two pieces of the hand strap into the bottom slots with the Velcro “hooks” strip facing up. (Figure 3) Pull it through until the retaining bar is snug against the case. Retaining bar Retaining bar Shorter Velcro strip (“hooks” facing up) Longer Velcro strip (“fuzzy” side facing down) Figure 3. Inserting hand strap halves 3.
Rugged Case - Chalice .fm Page 5 Monday, March 19, 2007 10:09 AM Installing the system To install your system into the rugged tablet case, perform the following steps: 1. 2. Position the case face down (the same orientation as when you installed the hand strap). Position the system in tablet mode with the display facing down, and hold it by the edge opposite the battery. Battery Rigid edge Figure 4. Inserting the system in the case 3. 4. 5.
Rugged Case - Chalice .fm Page 6 Monday, March 19, 2007 10:09 AM Flexible edge Figure 5. Enclosing the system Figure 6.
Rugged Case - Chalice .fm Page 7 Monday, March 19, 2007 10:09 AM Using the hand strap When you want to hold the case using the elastic hand strap, first separate the two halves. Place your hand in a comfortable position on the bottom of the system and re-secure the strap against the back of your hand. When not using the hand strap, attach it snugly against the back of the computer. Installing the handle To install the handle, perform the following steps: 1.
Rugged Case - Chalice .fm Page 8 Monday, March 19, 2007 10:09 AM 5. Repeat the procedure above with the other end of the handle. Figure 8. Inserting strap into buckle. Figure 9.
Rugged Case - Chalice .fm Page 9 Monday, March 19, 2007 10:09 AM Figure 10. Tightening the strap Installing the shoulder strap To install the shoulder strap, open the spring-loaded clips on both ends and attach one to each of the D-rings (Figure 11). Figure 11.
Rugged Case - Chalice .fm Page 10 Monday, March 19, 2007 10:09 AM Installing the pen tether To install the pen tether, insert one end into one of the Drings, then feed it through the loop on the other end. Pull it snug against the D-ring. Feed the loose end of the tether through the hole on the end of the pen, slide the loop over the tip of the pen, then down the barrel. Pull it snugly to tighten the loop.
Rugged Case - Chalice .
Rugged Case - Chalice .fm Page 12 Monday, March 19, 2007 10:09 AM 1250 E. Arques Avenue (M/S 122), Sunnyvale, California 94085 For more information, call 1-877-372-3473 or visit our Web site at: us.fujitsu.com/computers For technical support call: 1-800-8fujitsu (1-800-838-5487) or e-mail us at: 8fujitsu@us.fujitsu.com Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu, Ltd. All other trademarks mentioned herein are the property of their respective owners.
