User's Guide
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
5.1
Unpack
This procedure describes how to unpack the shipping package.
W arning: While unpacking the RU, do not remove the foam blocks attached to the antenna connectors, as
the foam protects the antenna connectors during installation.
Note: If the RU is not being installed immediately after unpacking, put the caps on the connectors of the RU
and store it in an area protected from rain and water in accordance with
Transport and Storage Requirements.
Step 1
Open the shipping package and carefully remove the contents.
Step 2
Place the RU on packing foam or an anti-static mat.
Step 3
Remove all packing foam that is around the heat sink and unit.
✓ This task is complete.
Installation
Unpack
71
Release 1.0 · Issue 1, March 2021
Fujitsu and Fujitsu Customer Use Only