User's Guide
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Compliance Information
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
When the device is so small or for such use that it is impracticable to label it with the statement specified under paragraph (a) of this
section in a font that is four-point or larger, and the device does not have a display that can show electronic labeling, then the
information required by this paragraph shall be placed in the user manual and must also either be placed on the device packaging or on a
removable label attached to the device.
This equipment has been tested and found to comply with the limits for Class A digital devices, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interferences when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio energy and if not installed in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference, which the user is required to correct at his/ her expense.
Class A Emission Limits
Standards for Class A Emission limits for North America as follows:
■ FCC Part 15, Class B (U.S.A.)
Product Safety Regulatory Standards
Product safety regulatory standards as follows:
■ UL 60950-22 (Safety for Equipment to be Installed outdoor)
■ UL 62368-1 (Communication Safety)
■ UL 50E (Enclosures for Electrical Equipment, Environmental Considerations)
■ CAN/ CSA C22.2 No. 62368-1
■ 47 CFR Part 1.130, RF Radiation Exposure
■ 47 CFR Part 15B, Unintentional Radiation
■ 47 CFR, Part 22, Public Mobile Services
■ 47 CFR, Part 24, Personal Communications Services
■ 47 CFR Part 27, Wireless Communications Services
■ 47 CFR Part 90, Private Land M obile Radio Services
■ 21 CFR Chapter 1, Subchapter J, Class 1 Laser Product