User's Guide

M easurement Freq.
1
f_offset is the separation between the channel edge
frequency and the centre of the measuring filter.
M inimum requirement
2
M eas BW Test tolerance
M aximum offset of OBUE outside the downlink operating
band
Δf
OBUE
(M Hz) : 10 MHz
1
For a BS supporting non-contiguous spectrum operation within any operating band, the emission limits within sub-block gaps is
calculated as a cumulative sum of contributions from adjacent sub-blocks on each side of the sub-block gap, where the
contribution from the far-end sub-block shall be scaled according to the measurement bandwidth of the near-end sub-block.
Exception is Δf ≥ 10 M Hz from both adjacent sub-blocks on each side of the sub-block gap, where the emission limits within sub-
block gaps shall be -16 dBm/ 100 kHz.
2
For a multi-band connector with Inter RF Bandwidth gap < 2* Δf
OBUE
the emission limits within the Inter RF Bandwidth gaps is
calculated as a cumulative sum of contributions from adjacent sub-blocks or RF Bandwidth on each side of the Inter RF Bandwidth
gap, where the contribution from the far-end sub-block or RF Bandwidth shall be scaled according to the measurement bandwidth
of the near-end sub-block or RF Bandwidth.
3
The requirement is not applicable when Δf
max
< 10 M Hz.
Spurious Emissions
Frequency Range M aximum Level* M easurement Bandwidth
9…150 kHz < –36 dBm 1 kHz
150…30 M Hz < –36 dBm 10 kHz
30…452.5 M Hz < –36 dBm 100 kHz
452.5…457.5 MHz < –96 dBm 100 kHz
457.5…462.5 MHz < –36 dBm 100 kHz
462.5…467.5 MHz < –52 dBm 1 M Hz
467.5…470 MHz < –36 dBm 100 kHz
470…607 MHz < –60 dBm 100 kHz
662…663 MHz < –60 dBm 100 kHz
663… 707 M Hz < –96 dBm 100 kHz
738…756 MHz < –52 dBm 1 M Hz
756…758 MHz < –36 dBm 100 kHz
758…768 MHz < –52 dBm 1 M Hz
768…777 MHz < –36 dBm 100 kHz
777…787 MHz < –96 dBm 100 kHz
787…788 MHz < –36 dBm 100 kHz
788…798 MHz < –96 dBm 100 kHz
798…807 MHz < –36 dBm 100 kHz
RU Hardware Feature
Performance Requirement
51
Release 1.0 · Issue 1, March 2021
Fujitsu and Fujitsu Customer Use Only