User's Guide
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
3.10
Performance Requirement
In this section:
3.10.1 eCPRI
3.10.2 Radio Performance
3.10.3 Power Supply
3.10.1
eCPRI
Line Bit Rate
The RU has one optical interface for eCPRI. Supporting eCPRI a line bit rate of at least 10 Gb/ s (10.3125 Gb/ s) is
necessary.
The RU is compliant with ORAN 7-2A Spec.
Each plane, for example, control, user, synchronization, management, are compliant with the following
documents:
Control, User, and
Synchronization Plane
ORAN-WG4.CUS.0-v02.00
M anagement Plane ORAN-WG4.M P.0-v02.00
Selecting Recovery Clock
The RU supports the following standards:
■ Telecom Slave Clock (T-TSC) to G8275.1
■ IEEE 1588 (PTP)
■ ITU-T G.8262 (SyncE)
■ IEEE1914.1
The RU supports Telecom Slave Clock (T-TSC) to G8275.1 and does not support G8275.2. The RU provides
additional noise filtering to filter fronthaul interface dynamic noise which will help meeting 3GPP frequency
accuracy requirement. The RU maintains sync holdover with SyncE, in case of PTP loss for 24 hrs.
RU Hardware Feature
Performance Requirement
45
Release 1.0 · Issue 1, March 2021
Fujitsu and Fujitsu Customer Use Only