Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specifications
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Prerequisites:
■ RU mounted and not powered up
■ Available AISG cables
Step 1
Is the cable being connected to the AISG port of the RU?
If YES:
Cont inue wit h next step.
If NO:
Proceed to Step 4.
Step 2
Inst all the AISG cable to the AISG port on the bot tom of the RU.
Step 3
Route the cable to the respective port on the antenna and this t ask is complete.
Step 4
Connect the AISG cable to the RET port .
Step 5
Tighten the out er connector shell to secure the cable. Repeat for the antenna end of the cable.
Cont inue with the next task.
5.7.4
Connect RF Cables
This procedure describes how to connect RF cables to the RU.
Prerequisites:
■ RU mounted and not powered up
■ RF Cables
Step 1
Remove the prot ective covers from the RF ports on the bot t om of the RU.
Step 2
If necessary, insert two weat herproofing sleeves onto each cable.
Installation
Cable Installation
101
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only