Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specification
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
Flat Washer
Split Washer
Lag Bolt
FNC001581_Rev_02
Figure 27
Attaching Wall M ount Plate to Wall Surface
Step 2
Torque each of the four bolts to 27 Nm.
Step 3
Place large insulat ing bushings on the wall plate by performing the following subst eps:
a) Peel the adhesive covering off of the large insulat ing bushings.
b) Align the st icky side of the bushings wit h the threaded holes on the lower front lip of the wall plate and stick
them in place as show n in the follow ing graphic.
Installation
RU Installation
94
Release 1.0 ยท Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only