Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specification
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
C.3
End Surface Cleaning In LC Connector
Prerequisite:
■ Clean the ferrule end surface wit h the provided stick type cleaner.
Step 1
Remove the connector prot ection cap.
Step 2
Insert the point of the cleaner straight int o the ferrule side of the connector. The point does not need to come in
cont act wit h the connector edges.
Step 3
Circle the ferrule seven times with the cleaner.
Step 4
Remove the cleaner and prompt ly connect the cable or install the prot ection cap.
✓ This task is complete.
Additional Instructions:
Caution: Do not touch surface aft er cleaning. Scars form easily on the connector's surface.
Caution: Do not use a cleaner except to clean the ferrule.
Optical Connector Cleaning
End Surface Cleaning In LC Connector
136
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only