Installation Instructions
Table Of Contents
- User Guide
- Contents
- Preface
- 1 About this Guide
- 2 Overview
- 3 RU Hardware Feature
- 3.1 System Configuration
- 3.2 RU Specifications
- 3.3 Environment Specification
- 3.4 RU Downlink/Uplink Default Parameters
- 3.5 Antenna Configuration
- 3.6 Carrier Configuration
- 3.7 Block Diagram
- 3.8 External Interface
- 3.9 TX Control Function
- 3.10 Performance Requirement
- 3.11 Mechanical Design and Other Options
- 4 Ordering Information
- 5 Installation
- 6 Operations
- 7 Maintenance and Trouble Clearing
- 8 Removal
- A References
- B ZTP Overview
- C Optical Connector Cleaning
- D Glossary
- Index
C.2
LC Connector End Surface Cleaning
Prerequisite:
■ Clean the ferrule end surface wit h the provided reel type cleaner.
Step 1
Remove the connector's protection cap.
Step 2
Hold the connector to the cleaner and move it wit h the arrow on the cleaning side of the cleaner. The connector
moves vert ically.
Caution: Do not rot ate the connector while cleaning.
2
3
Figure 43
Cleaning M ethod
Step 3
The connector rubs the ferrules on the cleaner.
Step 4
Rub the connector for between one and two seconds to prevent wrinkles.
Step 5
Do not use the same area on the cleaner a second time. If more cleaning is needed, use a different area on the
cleaner or a new cleaner.
Optical Connector Cleaning
LC Connector End Surface Cleaning
134
Release 1.0 · Issue 1, M arch 2021
Fujitsu and Fujitsu Customer Use Only