User's Manual

142
Appendix/Index
Note
●
If the software update could not be activated at the auto-update
time, the
(software update available) notification icon is
displayed on the status bar.
Activating software update
[Now update]
1
→
"Settings"
→
"About phone"
→
"Software
update"
→
"Start the software update"
→
"Yes"
●
The software update is automatically updated when the download
is started.
●
If you cancel a download midway, data downloaded till then is
deleted.
●
When the software update is not needed, "No update is needed."
is displayed.
●
If your FOMA terminal is in international roaming or out of the
service area, "Failed to start update. Due to no network or
roaming." is displayed.
●
If there is insufficient battery power for a software update, "Failed
to start update. Due to low battery. Please recharge and retry
later." is displayed.
2
Tap "OK"
●
Your FOMA terminal restarts and the update starts.
●
During an update, all key operations are disabled. The update also
cannot be canceled.
●
Your FOMA terminal restarts automatically twice during an update.
3
The standby screen is displayed
●
will be displayed on the status bar. Once you have checked
the
notification icon, it disappears.
143
Appendix/Index
Updating software immediately
1
"Starts update"
→
"
★はい★
"
2
When "Ready for update." is displayed, tap "OK"
●
Rewriting starts automatically about three seconds after "Ready
for update." is displayed.
●
During a rewrite, all key operations are disabled. The rewrite also
cannot be updated.
●
When rewriting ends, your FOMA terminal restarts automatically.
3
After your FOMA terminal restarts, the software
update starts automatically
●
During an update, all key operations are disabled. The update also
cannot be canceled.
●
About five seconds after the update ends, your FOMA terminal
restarts automatically.
4
Open the notification panel and tap the notification
●
The software update ends, and the standby screen is displayed.
●
The (software update completed) notification icon is displayed
on the status bar to indicate that the software update is completed.
Once you have checked the
notification icon, it disappears.
Post-update display
is displayed on the status bar of the standby screen. When you
open the notification panel, a message indicating that the software
update is completed is displayed.