User's Guide

FUJITSU COMPONENT LIMITED
12
OEM Warning statement (Module)
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC/IC identification number：
[English]
If using a permanently affixed label, the modular transmitter must be labeled
with its own FCC/IC identification number, and, if the FCC/IC identification
number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display
a label referring to the enclosed module. This exterior label can use wording
such as the following:
“Contains Transmitter Module FCC ID: SQK-7RAZXX, IC: 337L-7RAZXX”
Any similar wording that expresses the same meaning may be used. The
Grantee may either provide such a label, an example of which must be
included in the application for equipment authorization, or, must provide
adequate instructions along with the module which explain this requirement.
In the latter case, a copy of these instructions must be included in the
application for equipment authorization.
[French]
Si vous utilisez une étiquette collée en permanence, le transmetteur
modulaire doit porter son propre numéro d'identification FCC / IC, et si le
numéro d'identification FCC / IC n'est pas visible lorsque le module est
installé dans un autre appareil, l'extérieur de l'appareil dans sur lequel le
module est installé doit également afficher une étiquette faisant référence au
module inclus. Cette étiquette extérieure peut utiliser les libellés suivants:
«Contient le module émetteur, ID FCC: SQK-7RAZXX, IC: 337L-7RAZXX».
Tout libellé similaire exprimant le même sens peut être utilisé. Le bénéficiaire
peut soit fournir une telle étiquette, dont un exemple doit être inclus dans la
demande d’autorisation d’équipement, soit fournir des instructions adéquates
ainsi que le module qui explique cette exigence. Dans ce dernier cas, une
copie de ces instructions doit être jointe à la demande d’autorisation
d’équipement.
Information on test modes and additional testing requirements.
The modular transmitter has been fully tested by the module grantee on the required number
of channels, it should not be necessary for the host installer to re-test all the available
settings. It is recommended that the host product manufacturer, installing the modular
transmitter, perform some investigative measurements to confirm that the resulting
composite system does not exceed the spurious emissions limits or band edge limits.
The testing should check for emissions that may occur due to the intermixing of emissions
with the other transmitters, digital circuitry, or due to physical properties of the host product
(enclosure). This investigation is especially important when integrating multiple modular
transmitters where the certification is based on testing each of them in a stand-alone
configuration. It is important to note that host product manufacturers should not assume that
because the modular transmitter is certified that they do not have any responsibility for final
product compliance.
If the investigation indicates a compliance concern the host product manufacturer is
obligated to mitigate the issue. Host products using a modular transmitter are subject to all
the applicable individual technical rules as well as to the general conditions of operation in
Section 15.5, 15.15, and 15.29 to not cause interference. The operator of the host product
will be obligated to stop operating the device until the interference has been corrected.