User's Manual

23
IftheradioEncryptiontypeissettoWEPorapre‐sharedkey(WPA‐PSKorWPA2‐PSK),itshouldnowbecapableofobtaininganIP
address(eitherstaticallyassignedorthroughDHCP)andpassingtraffic.
IftheradioEncryptiontyperequiresEAP authentication thenanEAP Type
must be properlyconfiguredinorderforthedeviceto
obtainanIPaddressandbecapableofpassingtraffic.
<EAP type> Authenticated‐The radio has established a connection to an access point and has completed EAP authentication
successfully.
RadioType
Indicatesthetypeofradioinstalledinthedevice.For
example:
 BG ‐ IndicatesaSummit802.11gradiowhichsupports802.11band802.11g.
B. Profile Window
Profilesettingsareradioandsecuritysettingsthatarestoredforeachconfigurationprofile.Whenaprofileisselectedastheactive
profileontheMainwindow,thesettingsforthatprofilebecomeactive.
Notes:WhentheThirdPartyConfigprofileisselected,apowercyclemustbeperformed.
Thefollowingimage(in
Figure5.2)istheSCUProfilewindowsforWindowsCE
Figure5.2:SCUProfileWindow
ProfilechangesarenotsavedtotheprofileuntilyoutapCommit.
UsingScantoCreateaProfile
WhenyoutapScanontheProfilewindow,SCUdisplaysalistofthatarebroadcastingtheirSSIDs.Figure5.3belowisanexampleof
aScanwindow.