User Manual

【Enter Setup】
**【Exit Setup】 34
Timeout between Decodes
This parameter sets the timeout between decode sessions. When a decode session ends, next session
will not happen until the timeout between decodes expires. It is programmable in 1ms increments from
0ms to 65,535ms. The default setting is 1,000ms.
【Timeout between Decodes】
Set the Timeout between Decodes to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Timeout between Decodes barcode.
3. Scan the numeric barcodes “1”, “5”, “0” and “0”. (See the Digit Barcodes in
Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.