Fujian Newland Auto-ID Tech Hand-held Barcode Scanner : User Manual : Page 140

【Enter Setup】

**【Exit Setup】 130

Custom Suffix

Enable/Disable Custom Suffix

If custom suffix is enabled, you are allowed to append to the data a user-defined suffix that cannot exceed

10 characters. For example, if the custom suffix is “AB” and the barcode data is “123”, the Host will

receive “123AB”.

**【Disable Custom Suffix】

【Enable Custom Suffix】

Set Custom Suffix

To set a custom suffix, scan the Set Custom Suffix barcode and then the numeric barcodes

corresponding to the hexadecimal value of a desired suffix. To save the settings, scan the Save barcode.

Note: A custom suffix cannot exceed 10 characters.

【Set Custom Suffix】

Set the custom suffix to “CODE” (its hexadecimal value is 0x43/0x4F/0x44/0x45):

1. Scan the Enter Setup barcode.

2. Scan the Set Custom Suffix barcode.

3. Scan the numeric barcodes “4”,“3”,“4”,“F”,“4”,“4”,“4” and “5”. (See the Digit

Barcodes in Appendix)

4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)

5. Scan the Enable Custom Suffix barcode.

6. Scan the Exit Setup barcode.