User Manual

【Enter Setup】
117 **【Exit Setup】
Set Length Range for QR Code
The scanner can be configured to only decode QR Code barcodes with lengths that fall between
(inclusive) the minimum and maximum lengths. To accomplish it, you need to set the minimum and
maximum lengths.
【Set the Minimum Length (Default: 1)】
【Set the Maximum Length (Default: 1024)】
Maximum length of a 2D barcode should not exceed 1024 bytes. Minimum length is
not allowed to be greater than maximum length. If you only want to read QR Code
barcodes with a specific length, set both minimum and maximum lengths to be that
desired length.
Set the scanner to decode QR Code barcodes containing between 8 and 12
bytes:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3. Scan the numeric barcode “8”. (See the Digit Barcodes in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Set the Maximum Length barcode.
6. Scan the numeric barcode “1”.
7. Scan the numeric barcode “2”.
8. Scan the Save barcode.
9. Scan the Exit Setup barcode.