User's Guide

Enter Setup
** Exit Setup
34
Bad Read Message
Scan the appropriate barcode below to select whether or not to send a bad read message (user-programmable) when a
good read does not occur before trigger release, or the decode session timeout expires, or the scanner receives the Stop
Scanning command (For more information, see the “Serial Trigger Command” section in this chapter).
** Bad Read Message OFF
Bad Read Message ON
Set Bad Read Message
Abadreadmessagecancontainupto7characters(HEXvaluesfrom0x00to0xFF).Tosetabadreadmessage,scanthe Set Bad
Read Message barcode, the numeric barcodes representing the hexadecimal values of desired character(s) and the Save
barcode. The default setting is“NG”.
Set Bad ReadMessage
Set the bad read message to “F” (HEX:0x46):
1. Scan the Enter Setup barcode.
2. Scan the Set Bad Read Message barcode.
3. Scan the numeric barcodes “4” and “6” from the “Digit Barcodes” section inAppendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section inAppendix.
5. Scan the Exit Setup barcode.