User's Guide

Enter Setup
** Exit Setup
22
Image Stabilization Timeout (Sense Mode)
This parameter defines the amount of time the scanner will spend adapting to ambient environment after it decodes a
barcode and “looks” for another. It is programmable in 1ms increments from 0ms to 3,000ms. The default setting is 100ms.
Image Stabilization Timeout
Set the image stabilization timeout to 800ms:
1. Scan the Enter Setupbarcode.
2. Scan the Image Stabilization Timeoutbarcode.
3. Scan the numeric barcodes “8”, “0” and “0” from the “Digit Barcodes” section inAppendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section inAppendix.
5. Scan the Exit Setupbarcode.