User's Guide

230
Factory Defaults Table
Parameter Factory Default Remark
System Settings
Barcode Programming Disabled (Exit Setup)
Programming Barcode Data Do not transmit
Illumination On
Aiming On
Good Read LED On
Good Read LED Duration Short (20ms)
Power On Beep On
Good Read Beep On
Good Read Beep Duration Medium (80ms)
Good Read Beep Frequency Medium (2730Hz)
Good Read Beep Volume Loud
Good Read Vibration Off
Good Read Vibration Duration 300ms
Scan Mode Level Mode
Decode Session Timeout 3,000ms. 1-3,600,000ms
Image Stabilization Timeout (Sense Mode) 200ms 0-3,000ms
Reread Timeout
Disabled
1,500ms 1-3,600,000ms
Reset Reread Timeout Off
Image Decoding Timeout 800ms 1-3,000ms
Surround GS1 AI’s with Parentheses Off
Sensitivity Medium Sensitivity
Trigger Commands Disabled
Scanning Preference Normal
Read Barcode On
Decode Area Whole Area Decoding
Image Flipping Do Not Flip
Bad Read Message
Off
NG
OperatingMode 2.4G Mode
Default Interface USB HID Keyboard