User's Manual


5.INSTALLATIONOFACCESSORIES:
5.1.INSTALLINGTHEANTENNA:
Install the antenna as shown in the figure below and turn it clockwise until it stops.
Note:
‐Wheninstallingtheantenna,don’trotateitbyitstop,
holdingitbyitsbaseandturn.
‐Ifyouuseanexternalantenna,makesurethe‘SWR’is
about1.5:1orless,toavoiddamagetothetransceiver's
finaltransistors.
‐Donotholdtheantennawithyourhandorwraptheoutside
ofittoavoidbadoperationofthetransceiver.
‐Nevertransmitwithoutanantenna.

5.2.INSTALLINGTHEBELTCLIP:
If necessary, install the belt clip at the rear of the battery compartment cover as
shown in the figure below.
Note:
‐Donotuseanykindofgluetofixthescrewonthebeltclip.
ThesolventsGluemaydamagethebatterycasing.


5.3.MICROHEADSETINSTALLATIONOFEXTERNAL:

Plug the external micro-headset connector into the jack of ‘SP. & MIC’
of the transceiver as shown in the figure below.


5.4.–BATTERYINSTALLATION:
-When attaching the battery, make sure the battery is in parallel and in good contact with the
aluminum chassis. The battery bottom is about 1 to 2 centimeters below the bottom of the radio’s