User's Manual
to [-], so the transceiver will always 145,600 MHz in frequency and when
you press [PTT] to transmit transceiver, the frequency will automatically move to
145,000 MHz
Note: Under VFO mode, you can do like this. If you need the TX and RX frequency different
under Channel mode, you can directly store different RX and TX frequency into one channel
through MENU 27.
12.16.STE(TAILTONEELIMATION):
This function is used to activate or deactivate the transmission end of the transceiver. this
final tone transmission only be used in communications between transceivers and not in
communications through a repeater, which must be deactivated.
12.17.THEINSTRUCTIONSTOSAVECHANNEL
A complete memory channel includes RX frequency, TX frequency, CTCSS, DCS, RF Power,
Bandwidth, PTT-ID, BCL, ANI, Scan add to, Channel Name, etc. Except for the setting of Scan
add to and Channel Name, other settings could be finished by keypad under VFO mode.
Example: We want programming all the data into CH106, please do as following:
RX Frequency 440.625MHz
TX Frequency 430.625MHz
RX CTCSS 100.0Hz
TX DCS 250.3Hz
RF Power High
Bandwidth Wide
PTT-ID OFF
1. We have to check whether there are any data in CH106 or not. Come to MENU 28, if there is a
‘CH’ before ‘106’, that means there are data. So please delete it and you will find there is not a
‘CH’ before ‘106’, or else you can’t have new data in this channel.
2. Press and hold 【MENU】key, then power on, come to VFO mode. Press 【EXIT/AB】key to
select frequency A (UP).
3. Enter 440.625MHz
4. Now through the MENU, you can set other parameters. CTCSS,DCS, RF Power, Bandwidth,
etc.
5. After you finish all the other settings, press 【MENU】key, then come to MENU 27, press
【MENU】key two times, you will know all the data have been stored into CH106, however now
only RX frequency was stored. At the same time, you press 【MENU】key another two times,
you will store the TX frequency, of course the TX and RX frequency are same.
Note: If you want the TX frequency 430.625 stored into CH106, you should do the same
steps after you store the RX frequency into CH106.
12.18.CTCSS/DCSSCANNING
Before setting the CTCSS/DCS scanning, you should have a RX frequency and cancel the Dual
Standby function, ensure the radio is working under VFO mode.
Come to MENU 11, press【MENU】one time, then press [*/SCAN] key, at the same time, you should