User's Manual

transmitted.
‐“DT‐ANI”—undertransmittingmode,youcanheartheDTMFtone,whileyoupressthekeytotransmit
thecodeorthecodeautomaticallytransmitted.


12.11.SCREV(SCANRESUMEMETHOD):
Thistransceiverallowsyoutoscanmemorychannels,allthebandsorpartofthebands.
Whenthetransceiverdetectsacommunication,thescanwillstopautomatically.

Notes:
‐"TO"(TimeOperation):
Scanningwillstopwhenitdetectsanactivesignal.Thescanningwillstoponeachchannelor
activefrequencyforapredeterminedtime,afterthattimethescanwillresumeautomatically.
‐"CO"(CarrierOperation):
Thescanningwillstopandremaininthefrequencyorchannel,untiltheactivesignaldisappears.

‐"SE"(SearchOperation):
Thescanningwillstopandremaininthefrequencyorchannelafteritdetectsanactivesignal.
12.12. PTTID(PTTORRELEASEPTTTOTRANSMITTHESIGNALCODE):
‐Thisfeatureallowsyoutoknowwhocallyou.
‐“OFF”—Don’ttransmitthecodewhilepushthePTTbutton.
‐“BOT”‐TransmitthecodewhilepushthePTTbutton.(thecodeonlycouldbesetbyPCsoftware.)
‐“EOT”‐TransmitthecodewhilereleasethePTTbutton.
‐“BOTH”‐TransmitthecodewhilepushorreleasethePTTbutton.
12.13. BCL(BUSYCHANNELLOCK OUT):
TheBCLOfeature preventstheradio’stransmitter from beingactivatedif a signalstrong enough to break
throughthe“noise” squelchispresent.OnafrequencywherestationsusingdifferentCTCSSorDCScodes
maybe active, BCLOpreventsyou fromdisrupting their communications accidentally(because your radio
maybemutedbyitsowntonedecoder).
12.14. SFTD(DIRECTIONOFFREQUENCYSHIFT):
The "OFFSET" is the difference or offset between the reception frequency and the frequency of
transmission for access to amateur radio repeaters. Set the "OFFSET" according to
the "OFFSET" amateur radio repeater through which want to communicate.

12.15. OFFSET(FREQUENCYSHIFT):
When communicating via a repeater, the direction of displacement of
frequency should be timed to the displacement of the transmission frequency is
higher or lower than the receiving frequency.
example:
If we want to make a communication through amateur radio repeater whose frequency
input is 145,000 MHz and 145,600 MHz is output, we select the
"OFFSET" of the previous section in 0600 and the direction of travel "SHIFT" programmed