User's Manual

38 PONMGS(Bootdisplay) FULL/MGS
39 ROGER(toneendoftransmission) ON/OFF
40 A/B‐BP(Toneendofreception) OFF/A/B
41 RESET(Restoretodefaultsetting) VFO/ALL

12.2.SHORTCUTMENUOPERATION:
1.‐PressthekeyMENU,thenpressthekeyortoselectthedesired▲▼ menu.
2.‐PressthekeyMENUagain,cometotheparametersetting.
3.‐Pressthekey ▲ or ▼ toselectthedesiredparameter.
4.‐PressthekeyMENUtoconfirmandsave,pressthekeyEXITtocancelsettingorcleartheinput.








‐Note:
Underchannelmode,thefollowingmenusettingsareinvalid:CTCSS,DCS,W/N,PTT‐ID,BCL,SCANADD
TO,S‐CODE,CHANNELNAME.OnlytheH/Lpowercouldbechangedbypressing‘#’.
12.3.“SQL”(SQUELCH)
‐Thesquelchmutethespeakerofthetransceiverintheabsenceofreception. Withthesquelchlevel
correctlyset,youwillhearsoundonlywhileactuallyreceivingsignalsandsignificantlyreducesbattery
currentconsumption.
It is recommended that you set Level 5.
12.4.FUNCTION“V OX”(VOICEOPERATEDTRANSMISSION):
‐Thisfunctionisnotnecessarytopushthe[PTT]onthetransceiverforatransmission.Transmissionis
activatedautomaticallybydetectingtheradiovoice.Whenfinishspeaking,thetransmissionautomatically
terminatedandthetransceiverwillautomaticallyreceivesignal.BesuretoadjusttheVOXGainleveltoan
appropriatesensitivitytoallowsmoothtransmission.


12.5.‐SELECTWIDEBANDORNARROWBAND“W/N”:(12.5kHz/6.25kHz)
InareaswheretheRFsignalsaresaturated,youmustusethenarrowbandoftransmissiontoavoid
interferenceinadjacentchannels.

