User's Manual

Notes:
‐"TO"(TimeOperation):
Scanningwillstopwhenitdetectsanactivesignal.Thescanningwillstoponeachchannelor
activefrequencyforapredeterminedtime,afterthattimethescanwillresumeautomatically.
‐"CO"(CarrierOperation):
Thescanningwillstopandremaininthefrequencyorchannel,untiltheactivesignaldisappears.

‐"SE"(SearchOperation):
Thescanningwillstopandremaininthefrequencyorchannelafteritdetectsanactivesignal.
12.12. PTTID(PTTORRELEASEPTTTOTRANSMITTHESIGNALCODE):
‐Thisfeatureallowsyoutoknowwhocallyou.
‐“OFF”—Don’ttransmitthecodewhilepushthePTTbutton.
‐“BOT”‐TransmitthecodewhilepushthePTTbutton.(thecodeonlycouldbesetbyPCsoftware.)
‐“EOT”‐TransmitthecodewhilereleasethePTTbutton.
‐“BOTH”‐TransmitthecodewhilepushorreleasethePTTbutton.
12.13. BCL(BUSYCHANNELLOCK OUT):
TheBCLOfeature preventstheradio’ s transmitterfrombeing activated if asignal strong enough to break
throughthe“noise” squelchispresent.OnafrequencywherestationsusingdifferentCTCSSorDCScodes
maybe active, BCLOpreventsyou fromdisrupting their communicationsaccidentally (becauseyourradio
maybemutedbyitsowntonedecoder).
12.14. SFTD(DIRECTIONOFFREQUENCYSHIFT):
The "OFFSET" is the difference or offset between the reception frequency and the frequency of
transmission for access to amateur radio repeaters. Set the "OFFSET" according to
the "OFFSET" amateur radio repeater through which want to communicate.

12.15.
OFFSET(FREQUENCYSHIFT):
When communicating via a repeater, the direction of displacement of
frequency should be timed to the displacement of the transmission frequency is
higher or lower than the receiving frequency.
example:
If we want to make a communication through amateur radio repeater whose frequency
input is 145,000 MHz and 145,600 MHz is output, we select the
"OFFSET" of the previous section in 0600 and the direction of travel "SHIFT" programmed
to [-], so the transceiver will always 145,600 MHz in frequency and when
you press [PTT] to transmit transceiver, the frequency will automatically move to
145,000 MHz
12.16.STE(TAILTONEELIMATION):
This function is used to activate or deactivate the transmission end of the transceiver. this
final tone transmission only be used in communications between transceivers and not in
communications through a repeater, which must be deactivated.

