User's Manual

Battery Saver

This feature allows an idler radio to automatically enter battery saver mode,

the mode will extend battery service life, but response time may be delayed.

You can set battery saver time ratio as : 1:1、1：2、1:3、1:4, the time rate is

smaller, the power saving more evidently.

Via programmable software to set it: General Setting folder → Battery Saver

Lowery Battery Alert

When your battery gets low, LED indicator glows red and with a warning tone:

“Please Charge”，please replace the battery or charge the battery in time. The

radio will turn off automatically while battery is too low.

Via programmable software to set it: General Setting folder → Tone Alerts →

RX low battery interval (sec)

CTCSS/CDCSS

On analog channel, you can set unique CTCSS/CDCSS to guarantee the

privacy of your communication, if CTCSS/CDCSS has been set on the current

channel, CTCSS/CDCSS match is required for the radio to receive an

incoming signal. You can select a CTCSS/CDCSS from CTCSS frequency

table or CDCSS code table, or input non-standard CTCSS/CDCSS manually.

Via programmable software to set it: Channels folder→ Zone→ An analog

channel→ TX Parameters to select encode→ RX Parameters to select decode