User's Manual

1. All prompt tones ON/OFF: enable a user to enable or disable all prompt tones.
2. Battery capacity prompt: when the capacity is lower than the set value, the two-way
radio gives voice prompt.
3. Emergency mode ON/OFF: enable a user to establish or terminate an emergency call.
4. High/low power: enable a user to switch between high power and low power.
5. Monitor: enable a user to enable or disable monitor function. A user can enable the
monitor function to monitor the channel. In digital mode, a user can only check if there
is any activity before transmission, but not to ongoing actual voice or data
communication.
6. Permanent monitor: it has the same function as that of monitor (only for a handset), i.e.
allowing a user to monitor the channel to ensure that there is no activity before
transmission. The difference is that once permanent monitor is enabled, the two-way
radio will be kept in this mode before pressing this key to disable this function.
7. Unused channel deletion: enable a user to temporarily delete unnecessary channels from
the scan list (excluding selected channels). For example, when the two-way radio is
powered off and on again, deleted unused channels will resume in the scan list.
8. Single-key call 1: enable a user to perform digital group call, digital private call, call
prompt or send quick SMS.
9. Single-key call 2: same as single-key call 1.
10. Single-key call 2: same as single-key call 1.
11. Single-key call 2: same as single-key call 1.
12. Single-key call 2: same as single-key call 1.
13. Single-key call 2: same as single-key call 1.
14. Repeater/talk-around: enable a handset to connect or communicate via the repeater or
enable talk-around communication beyond the repeater.(prompt tone - "1" indicates
repeater and "2" indicates "talk-around".)
15. Unset: not assign any function to programmable keys.
16. Area switching: enable a user to switch between two areas. Note: each area has 10 channels.
It has two areas totally. (prompt tone -"1" indicates area 1, and 2 indicates area 2.)
17. Scan ON/OFF: enable a user to turn ON or OFF scan feature. (prompt tone: scan ON
and scan OFF)
18. Access authentication ON/OFF: enable a user to operate in normal mode and safe mode.
(prompt tone 1 indicates ON and 2 indicates OFF)
19. Disconnection: enable a user to disconnect from the relay. (prompt tone
instead of voice)
Note: above key functions can be realized by long or short press
on keys.
u Keys
1）Short press of orange key
l Enable a user to change short press of orange key. It has the same function as above.