User's Manual Part 2

Saja Operation Manual A-43
10/12/00
Appendix.fm Appendix
8. Insert the plug of the power cord into the AC outlet. Set the power
switch on the right side of the printer to [ I ] to turn on the printer.
9. Check the display and make sure the printer is ready for printing.
Important: If an error message is shown, see “4.3 Error Messages”.
Removing the duplex printing unit
To remove the duplex printing unit, proceed as described below.
1. Set the power switch on the right side of the printer to [0] to turn off the
printer. Then disconnect the power cord from the AC outlet.
Important: Removing the duplex printing unit while the printer is
turned on may result in malfunction.
2. Pull on the recessed area on the upper middle part of the rear side of
the printer, to open the cover.