User's Manual Part 2

Saja Operation Manual A-35
10/12/00
Appendix.fm Appendix
11. Insert the stub on the paper output tray into the hole of the HCS unit to
secure the HCS unit.
12. Insert the projecting part of the paper stopper into the hole at the
upper part of the paper exist slot.
13. Insert the plug of the power cord into the AC outlet. Set the power
switch on the right side of the printer to [ I ] to turn on the printer.
14. Check the display and make sure the printer is ready for printing.
Important: If an error message is shown, see “4.3 Error Messages”.
Removing the HCS unit
To remove the HCS unit, proceed as described below.
1. Set the power switch on the right side of the printer to [ O ] to turn off
the printer. Then disconnect the power cord from the AC outlet and
the printer.
Important: Removing the HCS unit while the printer is turned on
may result in malfunction.