User's Manual Part 1

4-2 Saja Operation Manual
10/12/00
Troubleshooting Chapter4.fm
4.1 Power-On Problems
This section describes problems that can occur when starting up the
printer. If the trouble still persists even after performing the checks listed
below, turn the printer off, disconnect the power cord from the AC outlet,
and contact your dealer or an authorized service station.
Warning:
Do not attempt to modify the printer in any way, to pre-
vent the risk of fire or smoke generation.
Caution:
Before cleaning the printer or performing any other mainte-
nance steps, be sure to turn the printer off and disconnect
the power cord from the
AC outlet, to prevent the risk of electric shock.
Description Possible Cause Action
There is no power. The power switch is not
turned on.
(The switch is not set to
[ I ].)
Check the power switch.
See “2.5 Turning the Printer
On and Off”.
The power cord is not prop-
erly plugged into an AC
outlet or into the AC con-
nector on the rear side of
the printer.
Set the power switch to [ O
] (off) and then connect the
power cord firmly.
See “2.4 Connecting the
Power Cord”.
Voltage of the AC power is
not correct.
Verify that the AC outlet is
rated for 100 V AC, 15 A.
Power is frequently
interrupted.
The printer is malfunction-
ing.
Turn the printer off and dis-
connect the power cord
from the AC outlet. Then
contact your dealer or an
authorized service station.