User's Manual Part 1

Saja Operation Manual 3-19
10/12/00
Chapter3.fm Daily Operations
3.4 Replacing the Fuser
When it becomes necessary, replace the fuser using the procedure
described below.
Caution:
Never touch the heater area (where a label indicating high
temperature is located), or else burns may result. If paper is
jammed at the heater or roller area, do not remove the paper
by force; otherwise personal injury may result. Instead,
immediately turn off the power and contact your local dealer
for assistance.
Warning:
Do not replace the fuser right after the printer has been
used. The high temperature may cause injury. Instead,
wait for the printer to cool down.
Caution:
Be sure to switch off and unplug the machine before access-
ing the interior of the machine for cleaning, machine mainte-
nance, or fault clearance. Access to a live machine’s interior
can cause a shock hazard.
1. Make sure the indication [PRINT RDY] is shown on the display.
2. Set the power switch on the right side of the printer to [ O ] to turn off
the printer. Then disconnect the power cord from the AC outlet.
PRINT RDY