User's Manual Part 1

2-2 Saja Operation Manual
10/12/00
Installation Chapter2.fm
2.1 Installation Precautions
To make optimum use of the printer, observe the following precautions.
Environment
Install the printer at a location described below.
Caution:
The installation surface must be stable and very sturdy to
support the considerable weight of the printer. If the printer
falls over, this will cause a severe risk of injuries.
Note: Place the printer on a table that is less than 700mm in height.
Placing the printer at a high location makes paper jam clearing
and the EP cartridge replacement difficult to perform.
Note: If there are drastic fluctuations in temperature or humidity,
condensation may occur inside the printer which will degrade
print quality. If this has happened, wait for at least one hour
before using the printer, to allow the moisture to evaporate.
Horizontal, sturdy and stable surface
Subject to direct sunlight
Exposed to vibrations
Subject to water and high humidity Subject to magnetic Subject to extreme variations in
temperature and humidity
Close to an open flameExposed to high levels of dust
and contamination
Close to heating appliances Exposed to direct air currents
Location with good ventilation Location with stable temperature
and humidity
Do not install the printer at locations such as those described below.