User's Manual

Setting the IP Address |

4 Click Configure the IP address settings Next.

5 Follow the on-screen instructions until the Configure Printer screen appears.

6 Click Advanced.

7 Specify the IP address settings according to your network environment.

8 Click Next, and then follow the on-screen instructions.

When Using the Operator Panel

1 Press the (Information) button.

2 Tap the Tools tab Admin Settings Network.

If Panel Lock Control is set to Enable, enter the password. See "Panel Lock."

3 Perform either of the following:

If the printer is connected to a network with the Ethernet cable:

Tap Ethernet.

For Dell H625cdw and Dell H825cdw:

If the printer is connected to a wireless network:

Tap Wi-Fi.

4 Tap IP Mode IPv4 Mode OK.

5 Tap until TCP / IP appears, and then tap TCP / IP Get IP Address.

6 Select how the IP address is assigned.

• To set the IP address automatically, select AutoIP, DHCP, BOOTP, RARP, or

Panel, and then proceed to step 7.

• To set the IP address manually, select Panel, and then perform the following:

a Tap IP Address.

The cursor is located at the first octet of the IP address.

b Use the number pad to enter the first octet of the IP address, and then tap .

The cursor moves to the next octet.

NOTE:

• You can only enter one octet at a time and must tap after entering each octet.

c Enter the rest of the octets, and then tap OK.

d Tap Subnet Mask.

e Use the number pad to enter the subnet mask, and then tap OK.

f Tap Gateway Address.

g Use the number pad to enter the gateway address, and then tap OK.

7 Turn off the printer, and then turn it on again.

Verifying the IP Settings

You can check the settings by using the operator panel, or printing the system settings

report.