User's Manual

202

| Loading Print Media

• Portrait orientation is preferred, especially when printing bar codes.

• Do not print within 1 mm (0.04 inch) of the die-cut.

• Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or

between die-cuts of the label.

• Do not print a label through the printer more than once.

Loading Letterhead, Pre-Printed, and Pre-Punched

Paper

Letterhead, pre-printed, and pre-punched paper must be inserted bottom edge first with

the print side facing down as shown in the following illustration.

NOTE:

• Make sure that Letterhead 2 Sided or Letterhead Duplex Mode is set to Enable, and Type

is set to Letterhead, Preprinted, or Prepunched on the operator panel even when printing on

a single side. You can also set the same setting using the print driver.

For Tray1 and optional 550-sheet feeder:

• Face up

• Letterhead enters the printer first.

For MPF:

• Face up

• Letterhead enters the printer first.

Linking Trays

The printer links the trays when you load the same size and type of print media in them.

The first tray is utilized until the print media runs out after which the next tray is used.

NOTE:

• The print media should be the same size and type in each tray.

The Multipurpose Feeder (MPF) cannot be linked to any of the tray sources.

After loading the selected trays with the same size and type of print media, select the

LETTERHEAD