User's Manual

178 | Dell™ Printer Configuration Web Tool
NOTE:
• If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the
operator panel.
802.1x
Specifies the settings for IEEE 802.1x authentication for encrypted communication to the
printer.
NOTE:
• This is available on Dell H625cdw and Dell H825cdw.
IP Filter
Specifies whether to enable IP filter feature, which allows to make settings of the IP filter
feature used for LPD and Port9100.
Re-enter
Pre-Shared Key
Enters the shared key again to check it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800 minutes.
IPsec SA
Lifetime
Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers
IPv4 address
Sets the IP address to connect to.
Remote peers
IPv6 address
Sets the IP address to connect to.
Non IPsec
communication
policy
Allows communication with a device which does not support IPsec.
Configure
802.1x
Enable IEEE
802.1x
Select the check box to enable IEEE 802.1x
authentication.
Authentication
Method
EAP-MD5 Selects the authentication method to use for IEEE
802.1x authentication.
EAP-MS-CHAPv
2
PEAP/MS-CHAP
v2
Login Name:
(Device Name)
Sets the login name (device name) for IEEE 802.1x
authentication using up to 128 alphanumeric
characters.
Password Sets the login password for IEEE 802.1x
authentication using up to 128 alphanumeric
characters.
Re-enter
Password
Confirms the set login password.
IPv4 Filter Enables or disables IPv4 Filter.
IP Filter Rule List Add, edit, or delete IP filter rule. Up to 20 rules can be registered.
IPv6 Filter Enables or disables IPv6 Filter.
IP Filter Rule List Add, edit, or delete IP filter rule. Up to 20 rules can be registered.