User's Manual

120 | Understanding the System Menus
❚ Admin Settings > Secure Settings >
Login Error
NOTE:
• Login Error feature is available only when Panel Lock Control is set to Enable.
Specifies whether to enable the Login Error feature, which specifies the number of error
entry attempts allowed when you log in as an administrator in Admin Settings and the
Report / List menu.
❚ Admin Settings > Secure Settings >
NFC Authentication
Specifies whether to enable the NFC Authentication setting, which enables the
authentication using the NFC authentication card.
NOTE:
• This is available on Dell H625cdw and Dell H825cdw.
❚ Admin Settings >
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
❚ Admin Settings > USB Settings >
USB Port
NOTE:
• USB Port setting is available only for the USB port on the rear of the printer.
Specifies whether to enable the USB Port setting, which enables the USB Port. The
change becomes effective after the printer is turned off and then on again.
❚ Admin Settings > USB Settings >
PS Data Format
Specifies PostScript Level3 Compatible communication protocol for a parallel interface.
You can configure the PS Data Format settings for the wired network. The change
becomes effective after the printer is turned off and then on again.
Show IPv4 Address
Show Host Name
Hide Network Information
Auto Used when auto-detecting the PostScript Level3 Compatible
communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP Used when the communication protocol supports both ASCII and
binary data to switch between them according to the specified
control code.
Binary Used when no special processing is required for data.