User's Manual

110 | Understanding the System Menus
❚ Admin Settings > System Settings > General >
Power Saver Timer
Specifies the time for transition to power saver mode.
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute
after it finishes a job. This uses much less energy, but requires more warm-up time for
the printer. Specify 1 minute if the printer shares an electrical circuit with room lighting
and you notice lights flickering.
Select a high value if the printer is in constant use. In most circumstances, this keeps the
printer ready to operate with minimum warm-up time.
Select a medium value if you want a balance between energy consumption and a shorter
warm-up period.
The printer returns to the standby mode from the power saver mode when it receives
data from the computer or remote fax machine. You can also change the status of the
printer to the standby mode by pressing any button on the operator panel.
❚ Admin Settings > System Settings > General >
Date & Time
Specifies the date and time formats.
❚ Admin Settings > System Settings > General >
mm / inch
Specifies the default measurement unit displayed after the numeric value on the touch
panel.
NOTE:
• The default for mm / inch varies depending on other settings, such as Country and Document
Size.
❚ Admin Settings > System Settings > General >
Screen Brightness
Adjusts the screen brightness of the touch panel.
❚ Admin Settings > System Settings > General >
Audio Tone
Specifies whether to enable the Audio Tone feature, which emits a tone during operation
or when a warning message appears.
Sleep Specifies the time taken by the printer to enter the Sleep mode after it
finishes a job.
Deep Sleep Specifies the time taken by the printer to enter the Deep Sleep mode
after it has entered Sleep mode.
Power Off Timer Specifies whether to enable the Power Off Timer and the time taken
by the printer to enter the Power Off Timer mode after it has entered
the Deep Sleep mode.
Time Zone Sets the time zone.
Date Sets the date depending on the Format settings.
Format Sets the date format.
Time Sets the time.
Format Sets the time format.