User's Manual

104 | Understanding the System Menus
❚ Admin Settings > Network >
Reset LAN
Initializes wired network data stored in non-volatile memory (NVM). After executing this
setting and restarting the printer, all wired network settings are reset to their default
values.
❚ Admin Settings > Network >
Delete All Certificates
Deletes all certificates of the printer. After executing this setting and restarting the
printer, all certificates are deleted.
❚ Admin Settings >
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
❚ Admin Settings > Fax Settings >
Fax Line Settings
Configures basic settings for the fax line.
❚ Admin Settings > Fax Settings > Fax Line Settings >
Fax Number
Sets the fax number of the printer to be printed on the header of a fax message.
NOTE:
• Make sure to specify Fax Number before using Junk Fax Setup.
❚ Admin Settings > Fax Settings > Fax Line Settings >
Country
Selects the country where the printer is used.
❚ Admin Settings > Fax Settings > Fax Line Settings >
Fax Header Name
Sets the sender name to be printed on the header on faxes.
❚ Admin Settings > Fax Settings > Fax Line Settings >
Line Type
Specifies the default line type to PSTN or PBX.
❚ Admin Settings > Fax Settings > Fax Line Settings >
Line Monitor
Specifies whether to enable the Line Monitor setting. Set the volume of the line monitor,
which audibly monitors a transmission through the internal speaker until a connection is
made.
❚ Admin Settings > Fax Settings > Fax Line Settings >
DRPD Pattern
Provides a separate number for faxing with a distinctive ring pattern.