User's Manual

102 | Understanding the System Menus
❚ Admin Settings > Network > Ethernet >
IPsec
NOTE:
• IPsec is displayed only when IPsec is enabled on the Dell Printer Configuration Web Tool.
Disables IPsec.
❚ Admin Settings > Network > Ethernet >
Connection Speed
NOTE:
• The Connection Speed setting is available only when the printer is connected to the wired
network.
Specifies the communication speed and the duplex settings of Ethernet. The change
becomes effective after the printer is turned off and then on again.
❚ Admin Settings > Network >
Protocols
Enables or disables each protocol. The change becomes effective after the printer is
turned off and then on again.
IP Address When an IP address is being set manually, the IP is allocated to the
printer using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value
in the range of 224 to 254 cannot be specified for the first octet of a
gateway address.
Subnet Mask When an IP address is being set manually, the subnet mask is specified
using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 255.255.255.255.255
cannot be specified as the subnet mask.
Gateway
Address
When an IP address is being set manually, the gateway address is
specified using the format nnn.nnn.nnn.nnn. Each octet that makes
up nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any
value in the range of 224 to 254 cannot be specified for the first octet
of a gateway address.
Auto
10BASE-T Half
10BASE-T Full
100BASE-TX Half
100BASE-TX Full
1000BASE-T Full
LPD
Port9100
FTP
IPP
SMB TCP/IP
WSD Print
*1
WSD Scan
Network TWAIN
SNMP UDP
*2