User's Manual

228 Understanding the Printer Menus
IPsec
NOTE: IPsec feature is available only when I
IPsec
is enabled on the D
Dell Printer Configuration Web Tool
.
Purpose:
Disables IPsec.
Reset Wireless
NOTE: Reset Wireless feature is available only when the printer is connected using the wireless network.
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network
settings are reset to their default values.
Connection Speed
NOTE: Connection Speed feature is available only when the printer is connected using the wired network.
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Va lu e s:
Wi-Fi Direct
NOTE: When the optional wireless adapter is attached and the Ethernet cable is disconnected, Wi-Fi Direct is displayed.
Purpose:
To configure the Wi-Fi Direct network settings.
Va lu e s:
Gateway Address When an IP address is being set manually, the gateway address is specified
using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in the
range of 224 to 254 cannot be specified for the first octet of a gateway
address.
Auto
*
Detects the Ethernet settings automatically.
10BASE-T Half Uses 10BASE-T Half-duplex.
10BASE-T Full Uses 10BASE-T Full-duplex.
100BASE-TX Half Uses 100BASE-TX Half-duplex.
100BASE-TX Full Uses 100BASE-TX Full-duplex.
1000BASE-T Full Uses 1000BASE-T Full-duplex.
Wi-Fi Direct Disable
*
Disables the Wi-Fi Direct network.
Enable Enables the Wi-Fi Direct network.
Group Role Auto
*
Use this option when you connect a Wi-Fi Direct certified device to the
printer.