Instruction Manual

70
From Configuration of Logger Mode to Completion of Measurement
Work outdoors to get the signal directly from
the GPS and adjust the time.
A location that is away from roofs or buildings
and open to the south is recommended to reduce
the time it takes to complete the sync (at which
point the GPS LED illuminates). Also, because
the GPS is located directly under the switch, if it
is covered or if you check it continuously, the
sync may take longer to complete.
① Turn on the pre-amplifiers.
② Turn on the main unit.
③ Verify that the pre-amplifier icons are lit.
④ Check the battery level and date and time of
the main unit and pre-amplifiers.
To change the date and time, see “3-6 Date
and Time Adjustment” on p. 25.
⑤ Press the menu switch .
⑥ Tap Equipment setting.
⑦ Check the time zone.
The date and time information obtained from
GPS is based on UTC (Coordinated
Universal Time). Set the time zone that
meets to your local time. If this setting is
incorrect, recording will not start at the set
time because the time on the pre-amplifier
and main unit will not match the triggering
GPS signal.
⑧ Press the pre-amplifier switch .
⑨ Select the All tab on the pre-amplifier setting
screen.
⑩ Set GPS to ON and the operation mode to
logger mode.