Instruction Manual

Safety Instructions
4
Compliance statement to FCC/IC
This module complies with part 15 of the FCC rules and IC RSS-210.
Operation is subject to the following conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF exposure compliance
1) To comply with FCC/IC RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of this
device and all persons.
2) This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Requirements to end product
This module must be integrated only by OEM integrators under the following conditions.
(1) OEM integrator has to be aware not provide information to the users regarding how
to install or remove this module in the user manual of the end product which
integrate this module. Installation by end users is strictly prohibited.
(2) Antenna
OEM integrator shall use this module without any modifications including antenna.
If module integrator uses a unique antenna, the FCC certification is required for the
end product.
OEM integrator must make sure that 20cm minimum separation is maintained
between users and the antenna.
(3) Co-location.
This module must not be co-located or operated in conjunction with any other
antenna or transmitter. The module integrator shall obtain FCC approval for the end
product, if the module is used for co-location operation.