Instruction Manual

21
Checking and Replacing the Battery (Main Unit)
(1) Checking the battery power
● Make sure that the battery level is high enough
before use.
When checking the battery level, turn on the
main unit.
When the battery is not fully charged, you will
see empty space inside the battery power
indicator as shown on the left.
If the battery power indicator is flashing,
immediately replace the battery with a charged
one.
Be sure to turn off the main unit before replacing
the battery.
● It is recommended that you bring a spare battery
when performing detection work so that the
device can be used even if the battery runs out
during the work.
(2) Opening and closing the battery cover and replacing the battery
The battery of the main unit is rechargeable.
Remove the battery cover and remove the
battery.
Insert the battery in the charger until it is
charged, then reinstall it.
Be sure to close the battery cover after inserting
the battery.
Warning
● Pay attention to the orientation of the battery
during replacement. (Failure to do this may
cause an explosion, fire, or injury.)
● Dispose of unneeded batteries in accordance
with your local regulations.
Note
● If a battery not specified by FUJI TECOM is
used, the warranty is invalidated even if a
malfunction occurs.
● Be careful not to throw away the battery
cover when disposing of the battery.
Battery power indicator
(1) Checking the battery power
(2) Opening and closing the battery
cover and replacing the battery
Rechargeable
battery
Battery cover