User Manual

6 15
AIR CAP SET SELECTION
Six additional size Setups are available as accessories. Size No.3
(1.3mm) is standard with all Fuji T-Spray Guns. 1.0mm, 1.3mm or
1.5mm can be used for any type of fine-finishing application. The
larger sizes such as 1.5mm allow for more fluid output - desirable with
fast drying lacquers.
If you do not intend on spraying walls & ceilings the only addi-
tional Setups you need would be the 1.0mm, 1.5mm, and 1.8mm.
No. 1 (Part 5100-1) .8mm (.031") SUPER-FINE OUTPUT
SHADING, STAINS.
No. 2 (Part 5100-2) 1.0mm (.039") FINE OUTPUT
SHADING, STAINS, WATERBORNE COATINGS.
No. 3 (Part 5100-3) 1.3mm (.051") FINE - MEDIUM OUTPUT - STANDARD
WATER-BASED LACQUERS, ACRYLICS, POLYURETHANE, STAINS.
No. 4 (Part 5100-4) 1.5mm (.059") MEDIUM OUTPUT
Similar to No. 3 but more coverage. Best for AUTOMOTIVE ENAMELS,
LACQUER and LATEX. Also VARNISHES, PRIMERS, OIL-BASED PAINTS.
No. 5 (Part 5100-5) 1.8mm (.070") HIGH OUTPUT
Larger surfaces, thick layers, spotted effects. SEALERS, VARNISH,
POLYURETHANE, OIL BASED PAINTS, ENAMELS, EPOXIES, ETC.
No. 6 (Part 5100-6) 2.0mm (.078") EXTRA HIGH OUTPUT
Very heavy flows, fast coverage. STONE FINISH PAINTS, TEXTURE
COATING, INDUSTRIAL PRIMERS, MULTI-FLECK PAINTS, LATEX on walls,
ceilings ETC.
No. 7 (Part 5100-7) 2.5mm (.098") MAXIMUM HIGH OUTPUT
Heavy flows, faster coverage. LATEX HOUSE PAINT on walls etc.
AIR CAP SET - Part 5100 Series